+49 40 670 570

Products

Productgroups

Applications

Projects

Downloads

PU Injection Resins

WEBAC® 1403P CE

WEBAC® 1403P is a CE-certified PU injection resin for crack injection in concrete elements. In contact with water the resin reacts to a fine-pored closed cellular foam with high chemical resistance, specially for contaminated facilities in agricultural sector and waste water disposals.

Direct request

Range of Application

  • Crack repair in concrete according to EN 1504-5
  • Injection of injection tubes (National Test Certificate)
  • Repair of waste water systems
  • Sealing of construction joints
  • Sealing of foundation pits


Properties

  • Polyurethan-based injection resin
  • Fine-pored closed cellular foam
  • Low viscosity
  • Good elasticity
  • High chemical resistance
  • Adjustable reaction time (accelerator WEBAC® B14)
  • With accelerator also suitable for use at low temperatures
  • Total solid


Application



WEBAC® 1403P: injection resin for closing, sealing and filling cracks

WEBAC® 1403P is a high quality, very low viscosity PU injection resin. WEBAC® 1403P is used for the closing, sealing and limited-flexibility filling of water-bearing, damp or dry cracks. The PU injection resin is also suitable for injection procedures via injection tubes to seal construction joints in concrete structures. WEBAC® 1403P is certified according to DIN EN 1504‑5 for areas relevant to structural stability (PU resin CE sign).


Fully cured WEBAC® 1403P provides for constant volume and chemical resistance

WEBAC® 1403P cures to form an inert, chemical-resistant resin of constant volume. Please note that lower temperatures will slow down the reaction, whereas higher temperatures will accelerate the reaction. At low temperatures (<10 °C) it is recommended to add accelerator (WEBAC® B14). The injection resin WEBAC® 1403P stands out due to its compatibility with masonry mortar,  concrete, steel, foil and cable sheathing materials. 

In case of water-bearing cracks under hydrostatic pressure it must be checked on site whether a preliminary injection of WEBAC PU injection foam resin is necessary. A preliminary injection is always required if the water pressure is so high that the injection resin would otherwise be washed out of the structure before it has fully reacted.



Any further questions?

Give us a call: +49 40 670 570